Tweet
fitted today....
pretty simple with the dremel and a marker pen
"offered up" to the wheel arch and marked with marker pen...
used the dremel to cut back...
when they fit perfectly, marked up the 2 fixing holes on the bottom of the BRAB side skirt and drilled... (about 5.5mm but as there is no space to get a drill in there i used an electric screw driver and a philips bit to make the hole - haha!)
hammered the large part into the hole fully and then popped the pin in and hammered that too...
because the arch liner if very flexible, i found that it wasn't possible to use the fixings on it so used a small brass self tapper and coloured the end black with permanent marker
job done!!
pics of them fitted...
JJ
pretty simple with the dremel and a marker pen
"offered up" to the wheel arch and marked with marker pen...
used the dremel to cut back...
when they fit perfectly, marked up the 2 fixing holes on the bottom of the BRAB side skirt and drilled... (about 5.5mm but as there is no space to get a drill in there i used an electric screw driver and a philips bit to make the hole - haha!)
hammered the large part into the hole fully and then popped the pin in and hammered that too...
because the arch liner if very flexible, i found that it wasn't possible to use the fixings on it so used a small brass self tapper and coloured the end black with permanent marker
job done!!
pics of them fitted...
JJ
